Do you know- the router is simply a box that facilitates all of your devices, both wired and wireless, to use that Internet connection at once. It also allows them to talk to each other without trying to do so over the web? Do you own an Xfinity router? Are you wondering how to reset xfinity router and fix its login problems? Then this blog is for you. It guides you with the Xfinity router admin password. It additionally counsels you on the Xfinity modem flashing orange issue.
Why is my Xfinity modem blinking an orange light?
The Xfinity Gateway starts Blinking Orange when it passes through a firmware update. If it isn’t successful, we recommend rebooting your router. Check your cables and the Ethernet connection you are using. The splitter may be a device that helps you transfer signals seamlessly. It is designed to separate your internet cable into three and offers a link to your phone, modem, and television. A malfunctioning or damaged splitter could also be a reason for the blinking orange light on your router. It inhibits the web connection from working.
To answer in short –
- Unplug the power cable.
- Wait one minute.
- Plug the power cable back in.
Restart with the Admin Tool –
- connect your router to your home network.
- Open a web browser on your device
- Type in http://10.0.0.1 in the search bar
- Go to the Admin panel.
- Navigate to Troubleshooting
- Hover over Reset/Restore Gateway.
- Unplug your device.
- Plug it back in.
- Turn off your Gateway’s Wi-Fi radio.
- You can turn it around After a few seconds.
- Reset the WIFI Router by rebooting a wireless router attached to a cable modem.
- Disconnect the Wi-Fi and restore the WIFI settings.
- Use the default network name (SSID) and Xfinity Router password across all your devices.
Login problems –
The most common reasons for this problem include:
- The default IP address is wrong, or it does not exist
- Hardware problems (including cable connections)
- You’re inputting incorrect credentials
To fix the issue –
- Restart or power cycle your Netgear router.
- Check whether all the wires and cables are firmly connected or not.
- Check the IP’s Default Gateway –
Ideally, the default IP of Xfinity gateways is 10.0.0.1. But, this is not always correct. If you enter it, you’ll find that the 10.0.01 IP address is incorrect, and it returns a connection timeout error.
- Access the Command Prompt.
- Type in ipconfig/all.
- Look for the category that says Default Gateway.
- The default gateway is the IP address of your modem/gateway.
If you’re sure that you didn’t change it, try out the following credentials:
Username: admin;
password: password
Username: admin;
password (leave it blank)
A look through the factory reset –
A factory reset acts by restoring your Gateway to its original default settings. It also includes your WiFi name and password. A factory reset demands the involvement of a non-metallic pointed object (such as a toothpick) to carry within the push button. It may also be present at the rear of the Gateway. Hold it for 30 seconds until all the LED lights power off. It may also prompt you to make a custom WiFi name and password. It allows you to reconnect devices to your home network using this information.
So the simple steps are to –
- Locate the reset button at the back of the gateway.
- Using a sharp object like a SIM card pin or a paper clip, press and hold the button.
- Keep it pressed for about 30 seconds or until the lights on the unit go off.
Implementing these steps can help you with the Xfinity modem orange light blinking and guide you through how to reset the xfinity router. We hope this blog enables you to troubleshoot your problem. Happy reading!